S1 Dream-T Espresso Machine
Owner’s Manual
Page 3
Introduction
First of all, thank you for your business! You are going to love your new S1 Dream-T
espresso machine. It combines classic beauty, value, and great performance for making
the best espressos, cappuccinos, and lattes you’ve ever tasted! These instructions include
tips that will help bring out the Barista that’s hidden within! Enjoy your new machine!
First Time Set Up
Remove the machine from the box and then tighten the legs on the bottom of the
machine if they have loosened in shipping.
Remove the water reservoir and rinse it thoroughly. It may be cleaned with mild dish
detergent, but it is not recommended for dishwasher use.
Before filling the reservoir, test your water for hardness with the provided test strips.
Fill a glass with cold tap water; dip the tip of the test strip into the water for one second,
then pull the strip out of the water and hold it horizontally for fifteen seconds.
Fill the reservoir with cold water making sure the in-tank softener pouch is laying on the
bottom of the reservoir.
Return the reservoir to the machine being careful not to spill any water inside. Then
push the drip tray into place and then it will lock down into notches on each side of the
frame so the reservoir does not back out.
Warning
: Do not turn the machine on until following the procedure on the next page or
damage to the machine will occur and will not be covered under warranty.
First Time Set Up - Filling the coffee boiler
WARNING:
DO NOT turn the machine on until the steps below have been completed.
Failure to do so will damage the machine and will not be covered under warranty.
Plug the machine into the electrical outlet, but do NOT turn it on. A GFI outlet is
recommended to better protect the machine, but is not necessary.
With the machine turned off press and hold the
button for approximately 5 seconds. The display will
then show the message shown to the right.
Press and hold either the single or double shot
