La Cornue CornuFe, Service Instructions Manual

Page: 16 / 36

16
SERVICING  WARNING  WORK SAFELY
Where necessary disconnect from electricity and gas before starting.
Check range is safe when you have finished.
4 To Remove the Control Panel
Remove all the control knobs. Open both oven doors. Remove 3 fi xings on the top front and 3 fi xings on the
control panel underside. Pull the control panel forward. It may be diffi
cult to move the control panel because it is
held by the cooktop. If so loosen the cooktop by removing the cooktop grates and burner heads and slacken the
brass venturi at the centre of each burner.
Remove the connections from the rear of the neons and light switches. Disconnect the earth lead and lift the panel
clear of the range.
Replace all parts in reverse order.
When replacing any electrical connections refer to the wiring diagram.
5 To Remove an Outer Side Panel
Move the range away from the wall - see ‘How To
Move the Range for Servicing’.
Remove the control panel – see 2.
Remove the plinth, 3 screws.
If a side extension is fi tted it must be removed
before the side panel can be unscrewed.
Undo the lower retaining screw situated below
the edge at the panel front corner.
Remove the 2 front side panel retaining screws
and the 2 on the rear of the side panel. Remove
the panel by pulling it away from the range.
6 To Remove an Oven Neon
Remove the control panel – see 2.
Remove the relevant neon connections and undo the nut which secures
the neon to the control panel.
Replace parts in reverse order. Ensure the replacement neon functions
correctly.