L2G VULCAIN-10, Manual

Page: 17 / 49

41
6.9 REPLACING THE HEATING ELEMENTS
Switch-off the oven and disconnect it from the electrical network before replacing the motorfan.
1) Lift the rack by a few centimetres from the side where lamp to be replaced is located, freeing it from the 2
latches that secure it at the bottom of the baking chamber (Picture 1 paragraph 6.5).
2) Tilt it by approximately 30° towards the centre of the oven and then remove it from the 2 pins that secure it
on the top of the cooking chamber (Picture 1 paragraph 6.5).
3) Repeat the operations with the opposite rack and then remove it.
4) Unscrew by hand the 4 pins that secure the fan casing to the bottom and top of the cooking chamber.
5) Gently remove the fan casing.
5B) If the oven is equipped with "steam" function, loosen the 3 screws that secure the water inlet pipe to the bot-
tom of the cooking chamber, turning it downwards and then release the fan.
6) Unscrew the nut that secures the fan to the motor and remove the fan .
7) Remove the back panel of the oven.
8A/B) Disconnect the heating element(s) from the electrical system.
9A) Loosen the 3 screws that secure the heating element to the bottom of the cooking chamber
10) Remove the heating element from the cooking chamber
8
A
9
B B
10
A
A
A
Replace the heating elements and reassemble the oven components by carrying out in reverse the procedure
described above.
6.10 ACTION IN CASE OF FAILURES OR LENGTHY INACTIVITY
•
Switch-off the oven and disconnect it from the electrical network.
• Reset all the knobs of the control panel for the mechanical oven versions while for the digital ovens ex-
clude the power supply by pressing the "0" of the power button.
• Get in touch with the technical assistance (only in case of failure).
• Clean the appliance internally and externally.
If the appliance is not used for long periods, cover the oven with a piece of cloth
16