BPA10T30W100
Broadband System User Manual
E-Mail: [email protected]
www.l2microwave.com
- 12 -
• Check for deficiency between amplifier output and load
-. It is recommended that VSWR of RF cable applied between amplifier output and load is less than 1.5: 1.
-. Check the VSWR of the load before connecting the amplifier and load.
Check the VSWR of the antenna connected to the output of the amplifier during the radiation experiment.
The minimum required VSWR for the antenna should be used under 1.5 : 1
.
If the operator wants to use it under high VSWR conditions, the amplifier's output can be used at a lower level.
The following table shows VSWR condition of Load vs. Output Power of BPA10T30W100.
Output power
VSWR Condition of Load
100W
Under 2.0:1
63W
Under 2.2:1
40W
Under 3.0:1