L.B. White AW060, Owner'S Manual And Instructions

Page: 51 / 80

Guardian Agricultural Animal Confinement Building Heaters
Owner’s Manual • Guardian
11
(Appearance of the outlet on heater may
vary from model to model.)
1. Air diverters can be installed in the brood heater
outlet to provide direction to the heated air as it
exits the brood heater. Refer to Fig. 1. Air diverters
can be installed to direct the air in either two 45
degree paths or in one 45 degree direction.
2. The air diverters may require hand forming prior
to installation. Make 90 degree bends utilizing the
perforations provided. The diverter halves should
then have the shape as shown in Fig. 1.
3. The air diverter’s tabs on each half will pop into
the blower outlet between the inside of the case
assembly and the blower housing outlet. If the
notched tabs do not pop into the blower outlet,
loosen the blower outlet screws. Doing this
provides a gap into which you can insert the tabs.
Retighten the screws after installation.
FIG. 1
Alternative Air Diverter Arrangements
1. Assemble according to Fig.2 and tighten all
eyebolts securely.
2. Be sure brood heater is securely fastened and is
hanging level. (Check crosswise and lengthwise
using a level.)
3. See Fig. 3 for typical indoor installation. In any
animal confinement building, consideration must
be given to making sure the brood heater is
located away from the livestock so that livestock
cannot knock the heater, tear it loose from its
mounting, or damage the heater or its gas supply
line in any way. Make sure you observe and obey
minimum clearance distances to combustible
materials as stated in the specification section
of this owner’s manual and on the brood heater
dataplate.
FIG. 2
EYEBOLT
NUT
FLAT WASHER
CAGE NUT
CHAIN
CASE TOP
FIG. 3
NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF
CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS,
THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT
LINE NO SMALLER THAN VENT OPENING.
VENT OF REGULATOR MUST
POINT DOWN AND REGULATOR
MUST BE VENTED OUTDOORS
MANUAL SHUT-OFF VALVE
CAN BE INSTALLED BEFORE
THE REGULATOR, UNDER
THE EAVE OF THE BUILDING,
OR AFTER THE REGULATOR
INSIDE THE BUILDING.
OPTIONAL INDOOR
REGULATOR
MOUNTING LOCATION
GAS HOSE
THERMOSTAT
CORD
YOKE
BROOD
HEATER
THERMOSTAT
0.3 m
BLACK PIPE
THROUGH WALL
VENT LINE
WALL OUTLET
POWER CORD
SEDIMENT
TRAP
WALL
CHAIN OR CABL
E
0.3 m
Air Diverter Installation
Instructions
(Must be ordered separately)
TABS
DIVERTER
HALVES
OUTLET
SCREWS
FORMED
OUTLET GUARD
NOTCHES IN MOUNTING TABS
Hanging Instructions
(Must be ordered separately)