Kyocera KM-6030, Service Manual

Page: 277 / 463

2FB/2FC
1-6-40
3. Hook the round terminals onto the catches on the inside of the scanner unit. (1)
4. Loop the scanner wires around the outer grooves in the pulleys on the mirror 2 frame, winding from below to above.
(2)
5. Loop the scanner wires around the grooves in the pulleys at the scanner unit right, winding from above to below. (3)
6. Wind the scanner wires around the scanner wire drum three turns from the rear toward the hole in the drum. (4)
7. Insert the locating balls on the scanner wire into the hole in the scanner wire drum. (5)
8. Wind the scanner wires five turns from the inner toward the hole in the drum. (6)
9. Install the scanner wire stoppers to the scanner wire drum to fix the wires. (7)
10. Loop the scanner wires around the grooves in the pulley at the scanner unit left, winding from below to above. (8)
11. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from below to above.
(9)
12. Hook the scanner wires around the scanner wire guides at the machine left. (10)
13. Hook the round terminals onto the scanner wire springs. (11)
Figure 1-6-80
Five turns from
the inner toward
Three turns from
the rear toward
Five turns from
the inner toward
Three turns from
the rear toward
Locating ball