5.5. Indicators and Messages
5-10
5HSODFH
:DVWHð
WRQHU ERWWOH
Replace the old waste toner bottle with the new one which is included
in the TK-20/TK-20H toner kit. The message will also be shown if the
waste toner bottle has become full. The waste toner bottle should be
replaced when the message display eventually shows
ý7RQHUýORZý
7.ðëíý&OHDQýSULQWHU
. See
Section 4.1
.
0LVVLQJ
:DVWHð
WRQHU ERWWOH
Install the waste toner bottle. See
Section 1.4
. The printer does not
operate when this message is displayed.
/RDGý SDSHU
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
The paper size does not match. The size of the paper in the cassette
is different to the size specified by the application software or by
PRESCRIBE 2e. Either put paper of the specified size into the cas-
sette. See
Section 1.4
.
If the
CONTINUE
key is pressed, printing will be resumed. However, if
more than one sheet is to be printed, the same message will again be
displayed from the second sheet onward. You can abandon printing
by pressing the
CANCEL
key.
/RDGý &DVVHWWHý ú
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
There is data for printing that matches with a paper cassette setting
(paper size, paper type), but there is no paper in the cassette. Set
paper into the paper source as displayed on the control panel, and
press the
CONTINUE
key to restart printing. However, the paper
source number (
ú
) is only displayed when there is an optional paper
feeder installed.
Or, if you want to print from a different paper source press the
FEED
key to display
ý8VHýDOWHUQDWLYH"
and you can change the
source for paper feeding. Further, you can change the paper source
by pressing the
FEED
key.
After selecting a paper source and pressing the
MODE
key,
ý3DSHUý
KDQGOLQJý!
appears. By pressing the
key, the paper type set-
tings menu appears. After setting the correct paper type, press the
EXIT
key and printing starts.
/RDGý 03ý WUD\
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
There is no paper cassette set (paper size, paper type) that matches
with the data for printing .
Because there is no cassette that matches the data, printing is done
from the MP tray. Set paper into the MP tray that matches the paper
size and type shown on the display and press the
CONTINUE
button to
restart printing.
Or, if you want to print from a different paper source press the
FEED
key to display
ý8VHýDOWHUQDWLYH"
and you can change the
source for paper feeding. Further, you can change the paper source
by pressing the
FEED
key.
After selecting a paper source and pressing the
MODE
key,
ý3DSHUý
KDQGOLQJý!
appears. By pressing the
key, the paper type set-
tings menu appears. After setting the correct paper type, press the
EXIT
key and printing starts.
Message
Corrective Action
