Installing the Page Printer
21
Test the interface with the computer
In order to check that the printer and the computer are properly connected you must print by sending an
actual command from the computer.
1.
Turn on the printer's power switch and turn on the computer’s power as well.
2.
Wait until the ON LINE/A4 indicator lights.
3.
Enter and execute the following command at the DOS prompt on the computer screen.
ECHO !R! STAT; EXIT;>PRN
If this causes the printer to print a status page, then the printer and computer are properly connected. If
this does not print a status page, check that the printer cable is properly connected. The cable or one of
the connectors may also be broken.
Notes on Application Software
The computer and printer have been successfully connected by the procedures up to this point. In order
to print from software run on the computer, it is necessary to install a printer driver on the computer to
which the printer is connected. After the printer driver is installed, be sure to make proper printer settings
from within the software.
Summary of Contents for FS-600
Page 61: ...Installing the Page Printer 41 Resident Scalable Fonts 1 ...
Page 62: ...Fonts 42 Resident Scalable Fonts 2 ...
Page 82: ...Index Index 2 Toner kit 43 W Windows 22 ...
Page 83: ......
