Kyocera Mita DP-2800, Instruction Handbook Manual

Page: 236 / 249

Appendix C Host Computer Interface
C-16
H7: Buffer nearly-empty threshold
This is a percentage from 0 to 99. The factory setting is 70.
The factory settings of the buffer nearly-full and nearly-empty thresholds (H6 and H7) are subject to
change without notification.
The gap between the nearly-full and nearly-empty thresholds allows the computer to send a fairly large
amount of data in a continuous stream.
H8: Received-data buffer size
This is the size of the input buffer, specified in units of 10K bytes. The factory-set value is 6 meaning
60K bytes.
PRESCRIBE 2e FRPO D0 command
The PRESCRIBE 2e FRPO D0 command is provided to allow manipulating XON/XOFF when an error
has occurred on the serial interface. The following table summarizes the error status corresponding to
different D0 values.
Serial interface error
error not handled error handled
Timing of XON transfer to
host while Ready or
Waiting XON sent every 3-5
seconds D0 = 0 (default) D0 = 1
XON not sent D0 = 10 D0 = 11