KYMCO UXV500, Owner'S Manual

Page: 74 / 88

72
GENERAL MAINTENANCE
BRAKES
Brake Fluid Inspection
Your UXV500 has hydraulically operated brakes and periodi-
cally you should inspect the level and condition of the fluid in
the brake fluid reservoir.
Inspect and adjust the brake fluid level in the reservoir using
the following procedure:
FULL
LOW
1. Open the hood
2. Check the brake fluid level; the brake fluid level should be
between the FULL and LOW marks on the reservoir
3. If the level is low, unscrew the reservoir cap and add DOT 3
brake fluid to bring level up to the FULL mark
4. Clean the reservoir cap with a clean cloth and replace it
5. Close the hood
Only use DOT 3 brake fluid from a sealed container.
Replace the brake fluid per the maintenance schedule.
POTENTIAL HAZARD
Brake fluid contacting the skin or eyes.
WHAT CAN HAPPEN
The fluid will cause irritation.
HOW TO AVOID THIS HAZARD
Avoid brake fluid contact with skin or eyes. In case of con-
tact, flush the affected area thoroughly with water and call
a doctor if your eyes were affected.
SHOCK ABSORBERS
Each shock absorber on your UTV should be visibly checked
weekly for excessive fluid leakage (some seal leakage is normal),
cracks or breaks in the shock body, or a bent shock rod. If any one
of these conditions is detected, replacement is necessary.
GENERAL LUBRICATION
Cables
Under normal use, the control cables on your UTV do not require
lubrication. However, it is advisable to lubricate the ends of the
cables periodically with a quality cable lubricant.
„ „
„ „
„
NOTE: If you drive your UTV in extremely cold weather
(-10
o
F / -23
o
C or colder), a small amount of fluid leak-
age may occur on the shock rod. Unless the leakage is
excessive, replacement of the shock absorbers is not
necessary.