46
Seal the Original Connector Panel Location
a.
Peel off the paper backing from the large
cover plate gasket supplied in the kitpack.
Attach the gasket to the supplied cover plate,
making sure all holes are aligned. Also make
sure all of the holes will align with the holes
at the original connector panel location,
gasket side facing down.
b.
Position the large cover plate and gasket
(gasket side facing down) over the original
connector panel location. Secure in place with
the five #4-40 screws and washers you
removed earlier (see Figure 73).
Prepare the Bottom Cable Access Hole
a.
Remove the two M4 screws from the small
cover plate and gasket inside the antenna
baseplate. Remove the small cover plate and
b.
Peel off the paper backing from the rubber
seal and carefully attach the rubber seal to the
underside of the baseplate, ensuring a good
seal around the rim of its bottom cable entry
Figure 73: Large Cover Plate and Gasket
#4-40
Screw (x5)
Large Cover
Plate and Gasket
Figure 74: Small Cover Plate and Gasket
M4 Screw (x2)
Antenna
Assembly
Small Cover
Plate and Gasket
Figure 75: Rubber Seal on Underside of Baseplate
Rubber seal
Note: You will route these
cables later in the procedure
Continued
Using the Bottom Cable Entry Kit
C
Summary of Contents for tracvision tv8
Page 1: ...TracVision TV8 Installation Guide ...
Page 50: ......
