KVH Industries tracvision tv8, Installation Manual, Page: 38 / 51

37
Configure the IP AutoSwitch
When performing system setup (see “Set Up the
System” on page 31 ), follow these additional
steps to configure the IP AutoSwitch.
NOTE: KVH recommends that you run the Setup
Wizard in the web interface whenever you change
your system’s configuration by adding or removing
devices.
a. At the AutoSwitch page of the web interface,
select Add IP AutoSwitch (Figure 59).
b. Enter the serial number and choose a friendly
name for the IP AutoSwitch (for example,
“Salon”).
c. Select Save to save your changes.
Select the Master Receiver
Any receiver connected to an IP AutoSwitch can
become the master receiver for the system. The
master receiver controls satellite selection.
a. To choose the master receiver, select it on the
Home page of the web interface, or press the
Master Select button on the associated
IP AutoSwitch.
b. Verify that the LED in the Master Select
button on the IP AutoSwitch is lit green (see
Figure 60). The LEDs for any other IP
AutoSwitches should be lit orange.
Figure 59: Add IP AutoSwitch Screen
140701234
The TV-Hub has a built-in IP AutoSwitch.
Any receiver connected directly to the TV-
Hub can therefore be selected as a master
receiver through the web interface.
IMPORTANT!
Figure 60: IP AutoSwitch LED Status Indications
LED Color Indication
Orange Registered with the system but
not currently the master
Orange,
flashing Initializing
Red Error:
• unable to communicate with
the system,
• network is not detected, or
• unable to register
Green Registered with the system
and currently the master
Continued
Installing an IP AutoSwitch
A