Cleaning and care
79
Cleaning and care
Safety
The following applies to all cleaning and care work:
Observe the safety information
Observe the safety information. Disregard for safety information
can lead to serious or fatal injury. See chapter »Safety«, page 6.
Secure the machine
•
Before starting cleaning operations, always switch off the
tractor's PTO shaft drive and secure it against accidental
restarting.
•
Secure the machine against rolling away by using chocks.
•
The machine must be standing on firm and level ground and, if
necessary, be supported during the work.
Unsecured or non-supported machines can cause accidents.
No persons in the working area
Ensure that no persons are present in the slewing and working area
of the machine. Persons could be caught by the machine within this
area. Fatal injury may be caused as a result.
Do not clean bearings or hydraulic parts with high pressure
cleaners
Do not clean bearings or hydraulic parts with high pressure
cleaners. The high-pressure cleaner removes the grease film from
uncoated metal surfaces. Metal surfaces treated in this way can
corrode. After each cleaning procedure, lubricate the bearing points
and grease uncoated parts.
Clean the bearings and hydraulic parts with care
Exercise caution when cleaning with a high-pressure cleaner.
Bearings, seals and pipe unions are not waterproof. In order to
prevent damage to the machine, the bearings, seals and pipe
unions must not be exposed to direct contact with the high pressure
water jets.
Summary of Contents for Vicon Andex 724
Page 107: ...EC Conformity Declaration 107 ...
Page 108: ...EC Conformity Declaration 108 ...
