58
Possible modifications
Change the release
force setting
The auto-reset beam's release force is correct if the beams are only
released during ploughing when they meet an obstacle.
The release force for the auto-reset beam can be changed by
•
adding or removing spring leaf no. 5
•
using a double spring kit
Carry out the following
> Release the spring tension, see page 57
> Change the configurations of the auto-reset beam's spring.
> Increase the spring tension again, see page 57
Type of springs
Release force*
kN
Standard
7.0
St 1 leaf no. 5
8.0
St 2 leaves no. 5 (Heavy Duty)
9.0
St 3 leaves no. 5
10.0
St 4 leaves no. 5 (Extra Heavy Duty)
11.0
St 5 leaves no. 5
12.0
Double ( 2 x standard)
14.0
*These values apply for low beams (under-beam clearance of 70 cm)
Standard
Heavy Duty
Extra Heavy Duty
Leaf F
No. 1
No. 2
No. 3
No. 4
Leaf F
No. 1
No. 2
No. 3
No. 4
No. 5
No. 4
Leaf F
No. 1
No. 2
No. 3
No. 4
No. 4
No. 5
