Possible modifications
57
To release the spring tension
> Park the plough on a firm, level floor.
> Support the beam correctly. Place a wedge under the rear of the
landside
> Loosen bolts
To apply spring tension
> Screw in bolt (X) halfway
> Screw in bolt (E), until the clearance between the spring suspen
-
sion rod (H) and the hole in the wall is 1-2 mm
> Screw in bolt (X) until the length of the spring is 70 cm.
> Tighten bolt (J)
T
IP
!
Use the long spanner to measure the length of the spring. The notches
on the spanner indicate 70 cm.
Loosen
Push forward
Loosen slightly
Bolt E
Bolt J
Bolt X
1-2 mm clearance
H
70 cm