Kvaser Memorator R SemiPro User’s Guide
19 (33)
4.4
Kvaser Memorator Tools
To log CAN traffic with the Kvaser Memorator R SemiPro, you need to create and
download a configuration to the device. The Kvaser Memorator R SemiPro needs
to be connected by the USB connector to a PC. Start the Kvaser Memorator Tools
application and press the Connect button in the toolbar. If the LEDs on Kvaser
Memorator R SemiPro are flashing in a “running light” pattern, the device is ready
to communicate with the Kvaser Memorator Tools program.
For further information about Kvaser Memorator Tools please refer to the
application’s online help.
4.5
Troubleshooting
•
Use “Kvaser Device Guide” in the Control Panel to verify
that the computer really can talk to the Kvaser Memorator R
SemiPro. Read out the firmware version. If it’s all zeros,
there are communication problems.
•
Verify that the disk is formatted. If in doubt, reformat it using
the Kvaser Memorator Tools.
•
If configuration fails, verify that the Kvaser Memorator R
SemiPro is in configuration mode when you are using the
Kvaser Memorator Tools. You can see this by looking at the
LEDs – they should flash in “running light” fashion.
•
Examine the pattern of flashing/illuminated LEDs on the
unit. Compare the observed pattern against those
described in Section 3.6, LED indicators, on Page 12.
•
If the LEDs are not flashing or illuminated at all, check the
power supply.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
