Kvaser Memorator R SemiPro User’s Guide
21 (33)
CAN Channels
2 (CAN 2.0A and 2.0B active).
CAN Transceivers (HS)
SN65HVD251 (Compliant with ISO 11898-2)
CAN Controller
Built into the M32C
Microcontroller
Renesas M32C
CAN Bit Rate
10 kbit/s to 1 Mbit/s
Timestamp resolution
2 µs
Error Frame Detection
Yes, both channels.
Error Frame Generation
Yes, when used as a USB-CAN interface.
PC interface
USB 2.0. Supports HiSpeed (HS) at 480 Mbit/s. Compatible
with USB 1.1 at 12 Mbit/s.
Power consumption
~5 V and 130 mA if powered from the USB and ~850 mW if
powered from the CAN connector.
External power
Power via the 15 pin D-SUB or the 9 pin D-SUB for channel
1.
Minimum operating voltage
6.2 V DC (cold start) and 5.6 V DC (during operation).
Maximum operating voltage
35 V DC.
Absolute maximum input voltage
48 V DC.
Software requirements
Windows Vista or later. (For other operating systems, see
Kvaser web or contact Kvaser support.)
Hardware configuration
Done by software (Plug & Play).
Dimensions (W x L x H)
31 x 220 x 19 mm (1.2 x 8.7 x 0.8 inch)
Operating temperature
−40
◦
C to +85
◦
C
Weight
179 g including cables and connectors. The adapter cable will
add another 77 g.
Storage temperature
−40
◦
C to +85
◦
C
Relative Humidity
0% to 95% (non-condensing.)
External trigger
Available in 15 pin D-SUB at pin relative ground pin 1 or on
CAN1 pin 4. The input is protected by a self-healing fuse
and has a 1 k
Ω
pull-up to +5 V. The firmware can detect both
rising and falling edges. The allowed voltage is 0 V to 5 V DC
relative to channel 1 ground.
External output
Available in 15 pin D-SUB at pin 5 relative to ground at pin 11
or on CAN2 pin 4. The output is a pull-down to ground and is
protected by a self-healing fuse. The allowed voltage is 0 V to
5 V DC.
Table 9: Kvaser Memorator R SemiPro Technical specifications
The two CAN channels are galvanically separated. Therefore,
when connecting both channels to the same bus, each channel’s
ground must be connected.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
