Kval DL-2, Instruction Manual

Page: 39 / 68

MAINTENANCE SCHEDULE
DAILY
1. Blow off dust from entire machine.
2. Lubricate linear bearings and chrome shaft with silicone.
3. Wipe down machine
4. Check tooling for wear
5. Empty water filter bowl if not a self draining system
6. Photo eyes should be wiped off and checked to ensure that all fastening rings are snug.
7. Check the air pressure
8. Check the Chip-Out blocks for wear.
9. Refill lubricator with proper type of oil (see lubrication requirements)
WEEKLY
1. Check machine for smooth motion through a complete cycle.
2. Clean linear bearings and chrome shaft, then lubricate.
3. Check air pressure to and on the machine
4. Adjust and lock flow controls.
5. Check all air lines & electrical wiring for kinks or rubbing.
MAY AND DECEMBER CHECK UPS
1. Wash filter and lubricator bowls with soapy water.
2. Grease all bearings and tighten all bolts.
3. Clean and lubricate all slides and cylinder rods with dry silicone spray.
* Carburetor cleaner can be used to remove pitch. If carburetor cleaner is used, re-lubricate
the affected surface.