Section 6—Testing Procedures
__________________________________________________
6.6
MODE
Select
Moving
SAME
OPP
Select
Opposite
or
FRNT
REAR
Select
Antenna
8. Lightly strike the lower speed tuning fork on a hard, non-
metallic surface. Place it approximately 1 inch in front
of the antenna. Verify that the patrol speed displayed is
the same as the speed stamped on the fork. While
holding the lower speed tuning fork in front of the
antenna, lightly strike the higher speed tuning fork on a
hard, non-metallic surface and place it in front of the
antenna at the same time.
The TARGET speed display should read the difference
of the two forks. Example: closing speed, 55, minus
patrol speed, 30, equals 25. (80 km/h minus 45 km/h
equals 35 km/h).
6.5.2 SAME DIRECTION TUNING FORK TEST
1. With the Directional Golden Eagle II in the moving
mode, depress the Opposite/Same switch on the remote
control, placing the unit in the Same-Direction mode.
Use the FRONT REAR switch to select the proper
antenna.
MODE
Select
Moving
SAME
OPP
Select
Same
Direction
or
FRNT
REAR
Select
Antenna
If not still in the TEST mode, depress the TEST switch
to restart the time for the TEST mode to allow tuning
fork testing.
