Section 6—Testing Procedures
6.3
Momentarily depress the TEST switch. Holding the TEST
switch depressed will light all displays. Upon releasing this
switch, the Directional Golden Eagle II will complete the
internal tests. If these tests pass, the TARGET window will
display "PAS" in the TARGET window. If the TEST button
is held depressed for greater than 10 seconds, the internal
test will proceed as a default condition.
NOTE: The unit will remain in the TEST state for 30
seconds after releasing the TEST switch, indicated
by the flashing STPW/TEST LED. Due to the
ability of the unit to reject non directional signals,
the operator must place the unit in this TEST mode
to read tuning forks. (See Sec. 6.5).
Depress the MODE switch to place the unit in the moving
mode, opposite direction. Depress the remote control
OPPOSITE/SAME switch if necessary. The opposite
direction road graphic indicator will be lit.
MODE
Select
Moving
SAME
OPP
Select
Opposite
or
FRNT
REAR
Select
Antenna
Momentarily depress the TEST switch. If the system is
working properly, the unit will proceed through the lamp
and internal tests as described above.
Internal test tolerance: + 0.
6.5 TUNING FORK TESTING
Supplied with the Directional Golden Eagle II are two
tuning forks, 30 and 55 MPH. These tuning forks will
simulate moving vehicles in the stationary or moving
modes.
