Kurzweil CUP2, Service Manual

Page: 44 / 84

Control Assembly
Removing the Control Assembly
The Control Assembly includes a bracket that attaches the assembly to the cabinet, the Control
Panel Board, and the control panel enclosure that slides in and out like a drawer.
Figure 4-8 Control Assembly hardware
1. Remove the four screws that secure the Control Assembly to the cabinet.
Caution:
Do not lower the Control Assembly more than a couple of inches, there is a cable
connected to the Control Panel Board.
2. Lower the Control Assembly and disconnect the  at ribbon cable from the Control Panel
Board.
3. Place the Control Assembly on your work surface.
Replacing the Control Assembly
1. Hold the Control Assembly in position and connect the  at ribbon cable from the Interface
Board to the Control Panel Board. If you removed a cable locking clip from the connector,
be sure to reinstall it.
2. Install the four screws that secure the Control Assembly to the cabinet.
Disassembly/Assembly
Control Assembly
4- 12