24
3BA00205 • 2020-10-28 • Rev. 5
Ersa i-CON
VARIO 2
Functional description
Removing/installing residual solder pots
■
Let the tool cool down to room temperature.
■
With a rotational movement, pull the residual solder pot out of the
holder.
■
To re‑install the residual solder pot, press it back into the holder with
a rotary motion until the edge of the container is level with the mark
-
ing on the handle.
Replacing filter plugs
The sintered filter disc should be cleaned respectively replaced at each filter plug change.
■
Remove the residual solder pot, as described in previous chapter.
■
Remove the filter plug from the residual solder pot.
■
Remove the lid of the residual solder pot with a rotary motion.
■
Clean the residual solder pot e.g. with the Ersa cleaning brush, order
no. 3N090.
■
Insert a new filter plug. It must be pushed backwards up to the nar
-
rowing of the residual solder pot ①.
■
Close the residual solder pot again.
Cleaning respectively replacing sintered filter discs
■
Remove the heating head, as described in chapter 6.8.5 [Replacing
the X‑TOOL VARIO heating head]
■
With tweezers, carefully remove the sintered filter disc from the
silicone holder.
■
Clean the sintered filter disc in an alcohol bath. Consider using an
ultrasonic bath to remove stubborn dirt.
■
Insert a new sintered filter disc into the silicone holder.
■
Re‑assemble the heating head, as described in chapter 6.8.5 [Replac
ing the X‑TOOL VARIO heating head].
■
Re-install the residual solder pot.
CAUTION! Material damage is possible!
Always make sure that the pre‑filter, filter plug and sintered filter disc are properly
installed before using the tool.
