37
3BA00205 • 2020-10-28 • Rev. 5
Ersa i-CON
VARIO 2
Functional description
6.4.10
Heating plate
You can use the soldering station to control the infrared heating plate 0IRHP100A.
The following accessories are needed:
•
Control cable from soldering station to the infrared heating plate 0IRHP100A
•
Y‑control cable given that the soldering smoke extractor and the infrared heating
plate 0IRHP100A are to be controlled together.
An infrared heating plate, a soldering fume extraction or both can be connected to the
station. With the i‑CON VARIO 2 you can operate up to two additional devices.
6.4.10.1
Connecting heating plate to soldering station
■
Connect the control cable of the heating plate with the interface connection A of
the soldering station.
■
Switch on the heating plate.
6.4.10.2
Activating the heating plate
■
In configuration mode select the menu [Heating plate] by turning the
i-OP.
■
Activate the cursor by pressing the i‑OP.
■
Activate the function by turning the i‑OP. The opposite display
appears.
■
Quit the configuration menu.
Information on working with the heating plate can be found in the chapter 6.2 [The
6.4.11
Activating the soldering fume extraction
You can use a soldering fume extraction with the soldering station.
■
Connect the solder fume extraction to the control cable and the latter to an inter
-
face connection (see page 14, no.
⑪).
A connected soldering fume extraction is activated automatically as soon as a tool is
taken out of the holder or is switched on.
6.4.12
Activating VAC PEN Mode
Enable the VAC PEN mode, in order to use the VAC PEN.
■
In configuration mode select the menu [VAC PEN Mode] by turning
the i-OP.
■
Activate the cursor by pressing the i‑OP.
■
Select the desired function by turning the i‑OP activate it by pressing
the button. There are 3 different modes available. Depending on the
selected mode one of the opposite displays will appear.
