27
3BA00205 • 2020-10-28 • Rev. 5
Ersa i-CON
VARIO 2
Functional description
6.3
Parameter mode
The following settings can be made in parameter mode:
• Nominal temperature (150 – 450 °C / 302 – 842 °F)
(i-TOOL AIR S 50 – 550°C/122 – 1020 °F)
•
Calibration temperature (−70 ... +50 °C/−126 ... +90 °F)
•
Peak offset (if required)
•
Energy function (3 stages)
•
Standby time (0 – 60 min)
•
Standby temperature (150 – 300 °C), except i‑TOOL AIR S.
Please proceed as follows to activate the parameter mode:
■
Select the corresponding tool with the i-OP.
■
Press the i-OP and keep pressed for 2 seconds.
The parameter mode is now activated for the chosen tool. The desired
parameter is selected by turning on the i-OP.
The last line shows a help text
②
regarding the selected parameter
①
,
which contains additional explanations or numerical ranges.
If no soldering tool is connected to the i‑CON VARIO 2 when the station is switched on,
you can, however, select a soldering tool in parameter mode and make your settings.
The selected tool is thereby marked by an arrow.
Proceed as follows to change a parameter value:
■
Press the i‑OP to activate the soldering tool the parameters of which
are to be changed.
■
Press the i-OP and keep pressed for approx. 2 seconds to open the
parameter mode for the active soldering tool.
■
Select the desired parameter by turning the i-OP.
■
Press the i‑OP to activate the cursor, pressing the i‑OP again
deactivates the cursor.
With the cursor is activated, turn the i‑OP to change the value of the parameter accordingly.
