GB
37
Glue the sealing tape onto the corner of the supporting edge of the
worktop so that no silicone adhesive can be pressed under the hob.
Place the hob into the worktop cut-out without any adhesive and align
it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-resistant
silicone adhesive.
Installation
Variable installation possibilities:
For installation, choose between:
Installation on top
Flush installation
1 Minimum clearance to adjacent walls
2 Opening dimensions
3 Cut-out dimension
4 Outer dimensions of hob
Important
Silicone adhesive must not get under the support surface. If this
occurs it will not be possible to remove the hob again at a later
stage. No liability will be assumed in the case of failure to observe
these instructions.
Important
There is a risk of breakage if the hob is canted or subjected to
stress during installation!
750+1
min.50
min.50
500+1
520
800
R5
4
51
11
5
166
1
1
2
2 4
4
4
84 x 455
Bracket
•
Insert the hob and align it.
•
From the bottom, insert the brackets with screws in the holes
provided for fastening the brackets, align the brackets and screw
them tight.
•
Tighten the screws with a hand screw driver only; do not use a
battery-operated screw driver.
•
In the case of thin worktops make sure that the brackets are
correctly positioned.
750+1
min.50
min.50
500+1
524+1
804+1
R7
4.5, -0.5
55
170
1
1
2
2
3
3
3
3
11
5
84 x 455
