Kuppersberg FT6VS09, Manual

Page: 15 / 20

GENERAL
Carefully read the contents of this leaflet since it provides
important instructions regarding safety of installation, use
and maintenance.
Keep the leaflet for possible future consultation.
All the operations relating to installation/replacement
(electrical connections) must be carried out by specialised
personnel in conformity with the regulations in force.
SAFETY WARNINGS
It is recommended to use flat-bottom pans with a diameter
equal to or slightly larger than that of the heated area.
Do not use pans with a rough base to prevent scratching the
heat surface of the cooktop (Fig.3).
Important:
- Avoid spilling liquid, therefore to boil or heat liquids, reduce
the heat.
- Do not leave the heating elements on with empty pots and
pans or without receptacles.
- When you have finished cooking, switch off the relevant
heating element with the control indicated below.
- Pay attention to easy to reach device parts as they over-heat
during use.
- Avoid spilling liquids like, for example, oil or other types of
grease, as they can cause fires.
- Do not attempt to put fires out using water. Turn off the hob
and cover the flame with a lid or fire-proof blanket.
- Do not leave objects on the cooking surface, it may cause
fires.
- If cable is damaged, have qualified personnel or After-Sales
Service replace it.
Attention:
- Steam cleaners must not be used.
- If the surface is cracked, switch off the appliance to pre -
vent electric shock.
- This appliance is not intended for use by young children
or infirm persons without supervision.
- Young children should be supervised to ensure they do
not play with the appliance.
- The appliance is not intended to be operated by means
of external timer or separated remote-control system.
This appliance conforms to the European Directive EC/2002/96,
Waste Electrical and Electronic Equipment (WEEE).
By making sure that this appliance is disposed of in a suitable
manner, the user is helping to prevent potential damage to
the environment or to public health.
The symbol on the product or on the accompanying
paperwork indicates that the appliance should not be
treated as domestic waste, but should be delivered to a
suitable electric and electronic appliance recycling collection
point.
Follow local guidelines when disposing of waste.
For more information on the treatment, re-use and recycling
of this product, please contact your local authority, domestic
waste collection service or the shop where the appliance
was purchased.
ENGLISH
GB
INSTALLATION INSTRUCTIONS
These instructions address specialised installers and serve
as a guide for installation, adjustment and maintenance in
conformity with the laws and regulations in force. If a built-
in oven or any other appliance that generates heat must
be fitted directly under the glass-ceramic cooktop, THIS
APPLIANCE (oven) AND THE GLASS-CERAMIC COOKTOP
MUST BE SUITABLY INSULATED in such a way that the heat
generated by the oven, measured on the bottom right of
the cooktop, does not exceed 60°C. Failure to respect this
precaution may determine improper functioning of the
TOUCHCONTROL system.
• Positioning (Fig.2):
The domestic appliance is designed to be built into a worktop
as illustrated in the specific figure. Apply sealant around
the entire perimeter (cut-out dimensions Fig.2B). Fix the
domestic appliance on the worktop by means of the 4 brackets
provided, taking the thickness of the worktop into account
(Fig.2A). If the lower part of the appliance, after installation, is
accessible via the lower part of the cabinet then it is necessary
to mount a separator panel respecting the distances indicated
(Fig.2C). If the appliance is installed with an oven underneath
then the separator is not necessary.
• Electrical connections (Fig.5):
Before making the electrical connections, check that:
- the ground cable is 2cm longer than the other cables;
- the system ratings meet the ratings indicated on the
identification plate fixed on the lower part of the worktop;
- the system is fitted with efficient earthing compliant to the
laws and regulations in force.
If the appliance is not fitted with a cable, use type:
“ H05V2V2-F ” for a power level of up to 6400 Watts. The
cross-section of the cable should be at least 2.5 mm², or 4
mm² for greater power levels. The cable should never reach
a temperature which is 50°C above the temperature of the
room in which it is installed. The appliance is designed for
permanent connection to the electricity supply and should
therefore be fitted with an omnipolar switch which has a
minimum opening of 3mm between contacts. The switch
should be suitable for the charge indicated on the appliance
data plate and must conform to all current legislation (the
yellow/green earth wire must not be interrupted by the
switch). The omnipolar switch must be easy to reach once
the installation process has been completed.
USE AND MAINTENANCE
• Use:
Use the touch control system for the position that corresponds
to cooking needs, keeping in mind that higher the selected
number is and the more heat is given off.
• Functioning (Fig.1):
A = ON/OFF button
B = Key button
B1 = Key button ON/OFF indicator
C = Timer Button “ - ”
D = Timer Button “ + ”
E = Cooking zone selector button
F4 - F6 = Double or triple cooking zone selection button
- 15 -