Kühtreiber MAKin 250 DP, Instructions For Use Manual

Page: 24 / 36

24 | en
MIG/MAG - setting the s4T function
the function allows setting of a multi-stage process (start power - welding
power - end power). to activate, press the control button one after the other.
use the FuNctioN button and turn the control dial n-coder i takes you to the
start / end power settings. the function value is corrected by means of the
control n-coder ii. By pressing and holding the control button, iNitial poWer
is activated → releasing the button activates WeldiNG poWer → pressing
and holding the control button activates eNd poWer → release the button
to complete the welding process.
Initial power - adjustable between 1-200 % of welding power. allows setting
higher than welding power.
Initial Arc Length (SAL) - active for double pulse only. allows setting the initial
arc length / voltage correction.
Welding power - main welding power
End power - adjustable from 1-200 % of welding power. it allows setting only
lower than welding power.
End arc length - only active with pulse. allows setting the arc end length /
voltage correction.
pulse double pulse function synergic manual
N-coder ii N-coder i control button s4t
pulse double pulse function synergic manual
N-coder ii control button s4t N-coder i
pulse double pulse function synergic manual
N-coder ii control button s4t N-coder i
pulse double pulse function synergic manual
N-coder ii control button s4t N-coder i
MIG/MAG - setting the sPoT WelDING function
(spot welding)
this function is designed for spot welding of materials and allows setting the
duration of the welding process. the function must be activated using the
control button. available only for pulse, syNerGic and maNual.
pulse synergic manual
control button spot funkction
MIG/MAG - setting the PoINT length
press the FuNctioN button and rotate the n-coder i sequentially to set the
point length. the function value is corrected with control n-coder ii.
N-coder ii N-coder i
pulse synergic manual
control button spot funkction