Kühtreiber MAKin 250 DP, Instructions For Use Manual

Page: 21 / 36

| 21 en
Function signaling FuNctioN button
tiG dc liFt N-coder ii N-coder i
TIG DC lIFT - setting the PosT-GAs function
this function ensures the protection of the weld after the welding process.
to activate, press the FuNctioN (Fn), select button the function is performed
by sequentially rotating the control n-coder i, setting the function parameter
by pressing the control n-coder ii. press FuNctioN (Fn) again to exit / confirm
the setting.
FuNctioN button
tiG dc liFt N-coder ii N-coder i
TIG DC lIFT - setting the 2-sTRoKe function
the function indicates how the welding process is activated. When using
this mode, it is necessary to press the control button during welding to send
a signal to activate the welding process. pressing the control button starts
the welding process and activates the sequence of functions. to activate,
press the control button one after the other.
tiG dc liFt
2-stroke control button
TIG DC lIFT - setting the 4-sTRoKe function
the function indicates how the welding process is activated. When using
this mode, it is necessary to press the control button, which sends a signal to
activate the welding process. the pre-Gas function is then activated, follo -
wed by start curreNt. When the button is released, the welding process
starts by switching to WeldiNG curreNt and activating other active func -
tions gradually. to complete the welding process, press the control button
again to activate the doWN slope function and then the eNd curreNt
function. When the button is released, the welding process is terminated
and the post-Gas function is activated.
tiG dc liFt
4-stroke control button
MIG/MAG - Welding process settings
Pulse - in pulsed arc welding, the base current alternates regularly with the
increased pulse current, resulting in a liquefied welding bath. this is a preset
controlled process. the user can make corrections to the welding process. the
process is particularly suitable for al and crNi materials and welding thinner
sheets.
Double Pulse - in double pulse welding, the pulse arc alternates regularly
in two sequences, reducing the thermal stress of the welded material and
the aesthetic standards similar to the tiG method. this is a preset controlled
process. the user can make corrections to the welding process. the process
is particularly suitable for al and crNi materials and welding thinner sheets.
Manual - the user must set the welding parameters manually. this is a stan -
dard process, depending on the set parameters, in a short / liquid arc.
Synergic - this is a preset controlled process. the user can make corrections
to the welding process.
pulse double pulse
syNerGic manual