5. Tighten the crankshaft position sensor mounting
screw (5) to the specified torque.
NOTE
• If replace the crankshaft position sensor,
measure the air gap between crankshaft
position sensor and flywheel.
Air gap
Service specifi-
cation
0.30 to 1.5 mm
0.012 to 0.059 in.
Tightening tor-
que
Crankshaft posi-
tion sensor mount-
ing screw (5)
9.81 to 11.3 N
⋅
m
1.00 to 1.15 kgf
⋅
m
7.24 to 8.33 lbf
⋅
ft
(4) Crankshaft position sensor
(5) Crankshaft position sensor
mounting screw
6. Install the boost pressure sensor (6).
7. Tighten the boost pressure sensor mounting screw
(7) to the specified torque.
Tightening tor-
que
Boost pressure
sensor mounting
screw (7)
9.81 to 11.3 N
⋅
m
1.00 to 1.15 kgf
⋅
m
7.24 to 8.33 lbf
⋅
ft
(6) Boost pressure sensor
(7) Boost pressure sensor
mounting screw
RELATED PAGE
4.31 Adjusting air gap between crankshaft position
sensor and flywheel on page 4-114
4.32 Adjusting air gap between camshaft position
sensor and pulsar gear on page 4-115
6.34 Installing common rail
IMPORTANT
• Replace the rail assembly, if the exchange of
the pressure limiter (1) or the rail pressure
sensor (3) is necessary.
NOTE
• Do not remove the pressure limiter (1) and rail
pressure sensor (3) from the common rail (2).
• When installing the common rail (2), do not hold
it by the pressure limiter (1) and rail pressure
sensor (3).
1. Install the common rail (1).
(1) Pressure limiter
(2) Common rail
(3) Rail pressure sensor
2. Connect the overflow pipe and hose (4).
3. Tighten the overflow pipe joint screw to the
specified torque.
4. Install the injection pipes (5).
4. ENGINE
SERVICING
6. Assembling
4-154
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
KiSC issued 12, 2018 A
Summary of Contents for D1803-CR-E4
Page 17: ...1 SAFETY KiSC issued 12 2018 A ...
Page 24: ...2 GENERAL KiSC issued 12 2018 A ...
Page 67: ...3 MAINTENANCE KiSC issued 12 2018 A ...
Page 100: ...4 ENGINE KiSC issued 12 2018 A ...
