4.18 Checking radial clearance of
turbocharger
1. Check the radial clearance between the wheel and
the housing.
NOTE
• If the wheel touches the housing, replace the
turbocharger assembly with a new one.
4.19 Checking injector
Tools required
• Circuit tester
1. Disconnect the injector harness.
2. Measure the resistance between injector terminals
(1) and (2).
Resistance
Service specifi-
cation
0.35 to 0.55 Ω
NOTE
• If the measurement is out of the service
specifications, replace the injector.
• When replace the injector, write the ID code
(3) of replaced injector in the engine ECU
with the diagnosis tool.
(1) Terminal high
(2) Terminal low
(3) ID code
(a) Injector
RELATED PAGE
7.56 Replacing injector on page 4-191
4.20 Checking suction control valve
(SCV)
Tools required
• Circuit tester
1. Place the key switch in the OFF position.
2. Disconnect the SCV wiring harness connector.
3. Measure the resistance between SCV terminals (1)
and (2).
Resistance
Service specifi-
cation
Approx. 2.1 Ω at 20
℃
(68
℉
)
NOTE
• If the measurement is out of the service
specifications, replace the SCV.
(1) Terminal SCV+
(2) Terminal SCV
－
(a) Suction control valve (SCV)
SERVICING
4. Checking and adjusting
4. ENGINE
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4-107
KiSC issued 12, 2018 A
Summary of Contents for D1803-CR-E4
Page 17: ...1 SAFETY KiSC issued 12 2018 A ...
Page 24: ...2 GENERAL KiSC issued 12 2018 A ...
Page 67: ...3 MAINTENANCE KiSC issued 12 2018 A ...
Page 100: ...4 ENGINE KiSC issued 12 2018 A ...
