ENGLISH
15
– Insert the woodruff key into the crankshaft and slide the flywheel onto the
crankshaft.
– Mount washer and hexagon nut.
– Hold the flywheel with the holding wrench and tighten the hexagon nut with
30 Nm (22 ft.lb.).
5.6 Mount and set the ignition coil
– Mount the ignition coil with 2 screws
1
. After tightening the screws it should
still be possible to move the ignition coil sideways.
– Measure the distance between flywheel and ignition coil at points
A
with a fee-
ler gauge and adjust the distance.
A
DMISSIBLE DISTANCE
: 0.25 - 0.35
MM
(0.01 - 0.015
IN
.)
– Tighten screws
1
and check distance again.
– Insert the rubber
2
into the opening of the housing and fasten the ignition cover
with the two retaining springs.
1
1
2
A
0,25
÷
0,35 mm
