07/FUEL TANK, SEAT, TRIM
66
11.1
Opening filler cap
100227-10
–
Lift the cover of the filler cap
and insert the ignition key.
–
Turn the ignition key 90° counterclockwise and remove the filler cap.
Info
The filler cap has a tank air vent system.
11.2
Closing filler cap
100228-01
–
Put the filler cap back on and turn the ignition key 90° clockwise.
–
Remove the ignition key and fold down the cover.
11.3
Removing the seat
100230-10
–
Pull on strap
and raise the rear of the seat at the same time.
–
Pull back the seat and lift it off.
11.4
Mounting the seat
100276-10
(690 Enduro)
–
Hook slot
of the seat onto screw
, press the rear downward and at the
same time push it forward.
–
Push locking pin
into lock housing
and push the back of the seat down
until the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
800096-10
(690 Enduro R)
–
Hook slot
of the seat onto screw
, press the rear downward and at the
same time push it forward.
–
Push locking pin
into lock housing
and push the back of the seat down
until the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
Summary of Contents for 690 Enduro AUS 2010
Page 2: ......
