01/FORK, TRIPLE CLAMP
29
200655-11
–
Install dust boot
.
200725-10
–
Mount adjusting tube
of the rebound damping in the cartridge.
The adjusting tube protrudes 5 mm from the cartridge and can be pressed in
against the resistance of the spring.
The adjusting tube protrudes more than 7 mm from the cartridge and cannot
be pressed in against the resistance of the spring.
–
Screw on fluid barrier
as far as it will go.
Info
The fluid barrier must be tightened as much as possible. Do not use tools.
–
Install the special tool on the cartridge.
Gripping tool (T14026S1) (
Info
The special tool must be used to prevent the adjusting tube being lifted and
thus to prevent oil from reaching the piston rod.
200726-10
–
Slide the cartridge into the inner tube.
–
Mount and tighten tap compression
.
Guideline
Tap compression
M29x1
35 Nm
(25.8 lbf ft)
Info
If the cartridge itself turns, press the piston rod slightly to one side.
200677-10
–
Clamp the fork vertically.
–
Fill it with fork oil.
Fork oil per fork
leg
620 ml
(20.96 fl. oz.)
Fork oil (SAE 5) (
Info
Pull out and push in the piston rod completely a few times to remove air
from the cartridge.
200678-10
–
Remove pin
of the special tool.
Gripping tool (T14026S1) (
–
Pull out the piston rod. Mount the spring. Mount the spring again.
Summary of Contents for 690 Enduro AUS 2010
Page 2: ......