KSP N305-150, Instruction And Maintenance Manual, Page: 35 / 42

64
11. Maintenance
This section describes the maintenance work which the Operator is allowed to carry out.
All maintenance work must be performed with the cable disconnected from the electricity supply.
Before buying or selling a used device, make sure that maintenance work has been duly
carried out and that it has been reconditioned by the Manufacturer.
Inspections, carried out at least once a month, must be recorded in the periodic inspection log
indicated in the paragraphs below. It is to make photocopies of the empty pages to be used as a
template for the entire working life of the device.
The following must be recorded:
- Date
- Name and surname of the person who carried out the inspection
- Any accessories used for the test. These must be marked to ensure identification
- Any operating or structural faults identified
- Corrective actions taken
-
Notification to the manufacturer of the faults identified
WARNING
During the periodic inspections or repairs, if any fault is identified or the product is left temporarily
unattended, a sign with the words ‘OUT OF SERVICE’ must be affixed to the patient lift.
11.1 Body support unit check (for example, stretcher slings) (each time before use)
Check the condition, check for damage, wear or potential yielding of the slings, rings, slots, or
supporting ropes.
If wear or deterioration of the lifting slots, belts or sling fabric is identified during the periodic
inspections, replace the part immediately.
11.2 Cleaning operations (as required)
Any painted parts must be carefully cleaned with a soft damp cloth. Chromed parts may be cleaned
65
with any spray normally found on sale. Do not spray the parts of the machine directly. Dry
thoroughly.
11.3 Cleaning the wheels (as required)
The wheels must be checked and cleaned for any metal parts or sticky residue which might have
collected on the surface.
11.4 Disinfection (as required)
The patient lift/patient stander must be disinfected with suitable, non‐corrosive products. The
disinfectants used must not contains phosphates, phosphorus or formaldehyde and must have a pH
of between 6 and 8. To disinfect the body support unit, refer to the use and maintenance manual
of the unit itself.
11.5 Replacing worn parts (as required)
If, during the periodic inspections, parts are identified as being damaged or worn, replace them
immediately by contacting the authorised support centres or by contacting the Manufacturer
directly. For the replacement of damaged parts, always use original KSP Italia parts and ensure they
are replaced by suitably trained technicians. Failure to do so will relieve KSP Italia of any liability for
damage or injury to persons or objects. Please refer to the specific paragraph for information
regarding the validity, limits and application of the warranty.
11.6 Lubrication (monthly)
Periodically and after any cleaning operation, it is recommended that the articulations are lubricated
with a few drops of pure Vaseline.
Never use jets of sprays of water or other substances on the device as this will damage the
surfaces.
11.7 Check the state of wear of the wheels (prior to each use)
Periodically check the condition of the wheels. Should they be damaged or worn out, you must
get in touch with the Technical Support Service.
146 147