KSP N305-150, Instruction And Maintenance Manual, Page: 13 / 42

20
 Insert the upper end of the electric actuator (8) into the dedicated flange located on
the upper boom (9) and fasten it in position with the pin (10) and the safety lock (11).
 Insert the release and actuation lever (12) in the support base (2) and fasten it in
position with the screw (13).
Use a male 3 mm hex key to tighten the screw (13).
 Assemble the N7953 leg rest footplate (patient stander version), inserting the relative
anchor supports (14) directly in the base (2).
Ensure it is locked in position by turning the locking screw (15).
Fig. A – Version N300 and N500
21
Connecting the electrical wiring (the numbering refers to the figure below)
Proceed as follows:
 To connect the electrical wiring of the actuator (1), insert the electric plug (5) into the
dedicated socket (4) of the control unit (3).

To connect the electrical wiring of the push‐button control panel (14), insert the
electric plug (7) into the dedicated socket (6) of the control unit (3).
102 103