KSB Ama-Drainer-Box, Operating Manual

Page: 38 / 72

5 Installation at Site
38 of 72
Ama-Drainer-Box
DANGER
Electrical connection work by unqualified personnel
Danger of death from electric shock!
▷
Always have shockproof plug or CEE motor protection plug type Hyper fitted by
a trained electrician only.
NOTE
Make sure that enough free cable length remains in the collecting tank which
allows the pump to be pulled out for service work.
ü
The discharge line has been connected.
ü
The float switch has been fitted.
1.
Place the pump set in the collecting tank.
2.
Connect the hose to the discharge outlet.
3.
Align the pump set.
4.
Slide anti-rotation device 710.00 into the opposite guide grooves and place it
onto the pump handle.
5.
Secure the pump set and the anti-rotation device using the two cable ties 81-73.
6.
Lay the power cables.
Ama-Drainer N 301 SE, N 302 SE, N 303 SE and N 358 SE/NE
with integrated magnetic float switch
5 m motor power cable N 301 to N 303 SE
10 m motor power cable N 358 SE/NE and variant C
With shockproof plug
Ama-Drainer 4../10 SE, 4.../35 SE, 5../10 K SE
10 m motor power cable (with float switch directly connected to the motor)
With shockproof plug
Ama-Drainer 4../10 SD, 4.../35 SD, 5../10 K SD
10 m motor power cable
10 m connection cable for float switch
With CEE motor protection plug, type Hyper
Underfloor box
1.
Remove the shockproof plug (new shockproof plug not included in the scope of
supply) or CEE motor protection plug type Hyper as applicable.
2.
Route the power cable of the pump set and the cable of the float switch, if any,
to the power supply through the vent line or a separate conduit using a draw
wire (fish tape).
Above-floor box
Pull the shockproof plug through the hole of the cable entry. On models with three-
phase motor remove the CEE plug type Hyper.