ID.: 17-16-20-2976-06 | 6.2017
33
NOTE
The device senses the evaporator temperature and it is lower than the temperature
of the surrounding air where the device is located or the air which the device takes
in.
The electric heater will perform a parallel activation at the set temperature. Shut-down of
electric heater occurs 30 minutes after the temperature of the evaporator is raised by 3 °C
above the value set with the parameter L.1.
7.3.11 Programme “Overheating-antilegionella”
Thermal disinfection or one-time overheating of water above 60 °C is activated with the key
HT
(indicator “1” is on). After the overheating finishes, the indicator “1” turns off. We can end
the overheating early by pressing the key
HT
again.
NOTE
The National Institute of Public Health advises water overheating once every
fourteen days.
NOTE
During the operation of the programme “Overheating-antilegionella” the indicator “1”
is on.
NOTE
In case the overheating is not successful in 12 hours, the function turns of and
continues with normal heating.
Adjusting the automatic overheating-antilegionella
Choose the parameter L.2, after a couple of seconds the set interval of overheating is displayed
(factory set to 14 days). During the display of the set value no. of days, it can be modified with
the key
or
(»- -« disabled or from 1 to 99 days). After setting the desired value, wait for
5 seconds, after the blinking stops the setting is saved.
NOTE
The National Institute of Public Health advises water overheating once every
fourteen days. Too frequent overheating is not advised because the energy
consumption with overheating is 1/3 higher than normal operation of the device.
7.3.12 Programme “Quick heating” of water
The programme is intended for one-time quick water heating with the device’s generator and
electric heater simultaneously in programmes “Automatic”
P.5
, “Photovoltaic P-V”
P.6
and
“External signal”
P.7
.
After the temperature is reached, the programme “Quick heating” turns off and goes back into
the previous operation setting. The programme is activated manually by pressing the key
HT
for approx. 10 seconds (indicator “1” blinks). After reaching the desired water temperature the
indicator turns off. We can end the quick heating early by pressing the key
HT
again.
