Krone Round Pack 1250, Original Operating Instructions

Page: 22 / 136

III - 2
Before and After Use
3.2 Hitching
Observe the maximum permissible support and hitching loads for the tractor!
Risk of hands and feet being pinched when the jack stand is actuated!
Hitch and secure the round baler to the tractor hitch in
accordance with specifications.
Set the jack stand in the transport position:
• Crank the support plate (3) upwards until pressure is
relieved on the jack stand (1).
• Remove stake bolt (2) and slide lower support pipe
upwards, securing it with the stake bolt (2).
• Turn the jack stand (1) to the upper position.
• Bring support chocks (4) into transport position.
• Turn support plate (3) in such a way that the flat side
faces the pick-up.
When connecting the hydraulic hoses,
make sure that the tractor and machine
hydraulics have been depressurized.
• Clean the hydraulic hose plugs (1),(2) and (3) before
connecting them.
• Draw the hydraulic hoses through the hose bracket
(4).
• Connect the hydraulic hoses (1),(2)and (3) to the
tractor hydraulics according to colour.
1. connection : tailgate operation red protective cap .
2. connection : pick-up operation (in case of Multi-Cut it's
possible to switch over to "0 knife position" if provided
on the control box)
yellow protective
cap .
RBR01171
1
2
4
3
PTO Shaft
• Push the PTO shaft (1) onto the tractor PTO shaft.
The safety mechanism must engage (see
the operating instructions provided by the
PTO shaft manufacturer).
• Secure the PTO shaft guard retaining chains (2).
KR-1-080
2
1
CPB00101
4
4
2
1
3