Krone Round Pack 1250, Original Operating Instructions

Page: 13 / 136

II - 3
Safety
2.2.5 Trailer Implements
1. Secure implements against rolling.
2. Observe the maximum supported load on the
trailer coupling, swing drawbar or hitch!
3. If a drawbar coupling is used, make certain that
there is enough play at the coupling point.
2.2.6 Power Take-Off Operation
1. Use only PTO shafts specified by the
manufacturer!
2. The guard tube and guard cone of the PTO and
the PTO guard must be attached and in good
working condition (on the implement side, too)!
3. Make sure that the required tube covers are in
place for PTO shafts in transport and working
position!
4. Before installing or removing PTO shafts,
disengage the PTO, switch off the engine and
remove the ignition key!
5. When using PTO shafts with an overload safety
or free-running coupling which are not shielded
by the guard on the tractor, mount the overload
safety or free-running coupling on the implement
side!
6. Always make sure that the PTO shaft is properly
installed and secured!
7. Attach chains to prevent the PTO shaft guard
from rotating with the shaft!
8. Before engaging the PTO shaft, make sure that
the selected PTO shaft speed of the tractor
matches the permissible implement speed!
9. Before engaging the PTO shaft, make sure
that no one is in the hazard area around the
implement!
10. Never engage the PTO shaft if the engine is
switched off!
11. No one should be in the vicinity of the rotating
PTO shaft when it is in use.
12. Always switch off PTO shaft when the angle is
too large or the PTO shaft is not required!
13. Caution! The flywheel will continue to rotate for
some time even after the PTO shaft has been
disengaged! Keep clear of the implement during
this time. Do not do any work on the implement
until the machine has come to a complete
standstill and the flywheel has been secured
using the hand brake.
14. Disengage the PTO shaft, stop the engine and
remove the ignition key before cleaning,
lubricating and adjusting the PTO shaft driven
implements or the PTO shaft! Secure the fly-
wheel with the hand brake.
15. Place the disconnected PTO shaft onto the
bracket provided!
16. After removing the PTO shaft, attach the
protective cover to the PTO shaft end!
17. If damage occurs, correct this immediately before
using the implement!
2.2.7 Hydraulic System
1. The hydraulic system is pressurized!
2. When connecting hydraulic cylinders and
engines, make sure that the hydraulic hoses are
connected correctly!
3. When connecting the hydraulic hoses to the
tractor hydraulics, make sure that the hydraulics
of both the tractor and the implement have been
depressurized!
4. In the case of hydraulic connections between
tractor and implement, the coupling sleeves and
plugs should be marked to ensure a proper
connection! If the connections are reversed, the
function will be reversed (e.g. raise/lower) -
risk
of accidents!
5. Check the hydraulic hose lines at regular intervals
and replace them if damaged or worn! The new
hoses must fulfill the technical requirements set
by the manufacturer of the implement!
6. When searching for leaks, use suitable aids to
avoid the risk of injuries!