21
Adjustments
3.3 Swather disc ground adjustment
Second swather discs on the KWT 8.50/8
and KWT 10.50/8x7
•
Move the rotary tedder into working position
•
Adjust the ground setting of the second swather
disc on the limiting stop (1)
•
Basic setting is a = 10 mm
•
If the ground is very uneven, the measurement can
be increased to a = max. 20 mm
Outer swather discs on the KWT 7.70/6x7
•
Move the rotary tedder into working position
•
Raise the outer swather discs slightly. The
stop (3) must not rest on the adjusting screw (2)
•
Undo the counter nut (1)
•
Turn the adjusting screw until in the required
position, (a = at least 41 mm).
•
Tighten the counter nut again after adjustment.
a
KWT-0-039
1
KWT-0-040
1
2
a
3
4
Second swather disc on KWT 8.80/8
Bring rotary tedder into working position. With the KWT
8.80 rotary tedder, the second swather disk’s
adjustment for the ground can be set on the tow bar
(1). For the basic setting, the bolt on the tow bar is set
with a gap of a = 1 cm. In cases of greater ground
unevenness, the dimension „a“ can be increased
where necessary. (The cylinder must not however
come into contact with the tow bar.)
KW-4-004
1
a