30
Putting back into operation
6 Putting back into operation
Special safety notes
•
Repair, servicing, maintenance and cleaning work should only be carried out when
the machine is at a standstill. Switch off the engine. Remove the ignition key. Secure
the tractor against rolling away.
•
All protective plates and protective devices should be reassembled correctly after
servicing and maintenance work has been completed.
•
Prevent oil or grease coming into contact with the skin.
•
Contact a doctor for injuries caused by escaping oil.
•
Follow all safety notes to avoid injuries and accidents.
•
Remove grease and oil used to preserve the
machine.
•
Carry out the measures given in the chapter
“Maintenance”.
•
Ventilate the overload coupling.
•
Carefully read through the operating
instructions again.
6.1 General
6.2 Overload coupling
KWT-0-033
1
2
3
The overload coupling (1) is located on the
PTO shaft (2). It should be connected to the main
gearbox.
Ventilate the overload coupling.
•
Tighten the four nuts (3)
•
Block the machine
•
Turn the PTO shaft by hand
•
Undo the nuts
NOTE
Also see maintenance notes from the PTO shaft
manufacturer on the PTO shaft.
