Krone 4XL-RGD, Operating Instructions Manual

Page: 36 / 84

III - 14
Operation
3.10.5 Emptying process
• When opening the rear flap, nobody must remain within the area where it swings open.
3.10.4 Preparation for the emptying process
• Before starting the emptying process, switch on the
hydraulic sytem on the tractor.
• Switch on the on-board electronic system.
• The automatic loader must be switched to (Off).
Before driving over the silo
No persons are permitted inside the
danger area.
• Only extend the articulated tow-bar as far as is
necessary.
• The steering axle (special fitting) must be locked
when driving over a silo.
To do this, before passing over, pressurise the
hydraulic connection until the steerable wheels have
straightened.
It may also be necessary to drive a short distance
forwards or backwards in a straight line .
When passing over the bin, leave the pressure on the
hydraulic connection as it is.
• Open the rear flap.
When the rear flap opens the cylinder for
switching on the metering rollers is
automatically activated.
To ensure proper operation of the metering
rollers, the switch for the rear flap must be
held for another 1 - 2 seconds after the
green lamp lights up.
• Switch on power take-off shaft.
• Switching on power take-off shaft when emptying only to be carried out if idling and with
rear flap open.
• Switch on scraper floor and set speed according to
type of load, compression or load height.
• Only use fast speed for emptying residual material.
The scraper floor only runs if the rear flap
is completely open (green indicator lamp
must light up) and if metering rollers are
turning.