Operation & Installation Manual V12-V6 2010-05-31.doc
31/05/2010
22/60
3
Before installation
3.1 Inspection received products
3.1.1. Packing and transportation
The standard packaging of an ultrasonic gas flow meter is in a reinforced wooden seaworthy
crate. This crate is suitable for road, railroad and sea container transportation. It is advisable
to install Indicators inside the crate to detect impact during transportation, which may lead to
malfunction of the equipment. In the event an impact detector shows incorrect handling
during transportation contact KROHNE for assistance on handling warranty and repair
procedures, even if no outer damage is visible to the equipment it is advised to inform
KROHNE about the issue. Problems might come out at a later stage during commissioning
and start-up.
3.1.2. Scope of delivery
INFORMATION!
Check the packing list to see if you have received all the parts ordered.
The ALTOSONIC V12 will arrive in a wooden crate. Carefully unpack the UFM: remove the
crate’s lid, unscrew the protecting beams or release the strap belts. Lift the UFM from the
crate’s floor using the lifting lugs or eye bolts.
3.1.3. Name plate
CHECK!
Check on the device nameplates, that the device is supplied according to your order.
In particular check the following data specified on the name plate:
•
pressure rating
•
temperature rating
•
power supply voltage
•
material of pressure containing part
These specifications should be in agreement with the requirements of your application. If not,
contact your local KROHNE representative for advice.
3.1.4. Visual check
CHECK!
Check the meter for any signs of damage that might be caused by transportation. In case
damage is suspected, contact your local KROHNE representative.
3.2 Storage
INFORMATION!
In between factory release for transportation and final installation the equipment may be held
in storage for some time. Maintain the following storage conditions to prevent the equipment
from corrosion or early failure: