30
31
English
English
SPARK PLUG INSPECTION
The spark plug is important
engine components,
which should be checked
periodically.
1. Remove the cap (1) and
spark plug cap (2),Insert
the tool (4) through the
hole from the outside of the
cover.
2. Insert the handlebar (3)
in to the tool (4) and turn it
counter clockwise to remove
the spark plug.
3. Check for discoloration
and remove any carbon
deposits. The porcelain
insulator around the center
electrode of spark should be
4. Check the spark plug
type and gap
5. Install the spark plug
6. Install the spark plug cap
and spark plug cover.
Spark plug type:
E6RTC
NGK: BPR6HS
CHAMPION: RL87YC
DENSO: W16FRP
BOSCH: WR6BC
BERU: Z19
Gap: 0,6-0,7mm
(0,024-0,028in)
TIP: If a torque wrench is not available when
installing a spark plug, a good estimate of the correct
torque is 1/4-1/2 turn past finger tight. However,
the spark plug should be tightened to the specified
torque as soon as possible.
CARBURETOR ADJUSTMENT
The carburetor is a vital part of the engine. Adjusting
should be left to a dealer with the professional
knowledge, specialized date, and equipment to do so
properly.
CLEAN FUEL FILTER
1.Unscrew but unloosen the
screw (1) and take off the
left exterior cover (2).
2.Drain the fuel in the fuel
tank. Hold the tube clip (3)
toward downward and pull
out the fuel tube (4) which
connect on the fuel tank,
then disassemble fuel filter.
3.Put the fuel filter (5) into
noncombustible or higher
flash point solvent and
clean it.
4.Assemble fuel filter to
the main jet (6) on the fuel
tankthen assemble fuel tube
to main jet on the fuel.
ENGINE OIL REPLACEMENT
Avoid draining the engine oil immediately after
stopping the engine. The oil is hot and should be
handled with care to avoid burns.
Do not tilt the generator when adding engine oil. This
could result in overfilling and damage to the engine.
1. Add engine oil to the upper level.
2. Wipe the cover clean, and wipe up any spilled oil.
3. Be sure no foreign material enters the engine.
4. Oil and gasoline could pollute the environment,
don’t throw it in the trash or pour it on the ground.
1.Place the generator on a
level surface and warm up
the engine
for several minutes.
2.Unscrew but unloosen the
screw (1) and take off the
sight glass of
engine oil (2).
3.Lift and incline the
machine; take off the end
cap (3) at the bottom
plate of machine.
4.Remove the oil filler cap.
(4).
5. Place an oil pan under
the engine, remove the oil
drain bolt (6)drain the oil
from the oil tank.
6. Check oil filler cap (4),
O-ring (5), Oil drain bolt
(6), Oil filler cap packing
(7). Replace immediately
new one if it damages.
7. Assemble oil drain bolt
and oil filler cap packing.
8. Add oil till to a suitable
level, tighten oil filler cap.
9. Assembly the end cap at
the bottom of machine .
10. Assembly the sight
glass of engine oil.
AIR FILTER
1. Unscrew but unloosen the screw (1) and take off
the left exterior cover (2).
2. Remove the air filter cover and foam element.
3. Wash the foam element in solvent and dry it.
4. Add oil for the foam element and squeeze out
excess oil. The foam element should be wet but
not dripping, avoid be damage.
5. Insert the foam element into the air filter case.