Krautzberger 200-0415, Operating Instructions Manual

Page: 40 / 53

Spray pattern Error Cause Remedy
Spray pattern too thin n Cap nut loose n Tighten the cap nut
Material jet comes out
in spurts or rapid
bursts n Insufficient mate-
rial supply n Increase the material
supply
n Blocked material
path n Clean
n Loose or dam-
aged material
nozzle n Tighten or replace (
Ä
Chapter 8.5
‘Changing the material
nozzle and the air
nozzle’ on page 32
).
n Worn needle seal n Replace the needle
seal (
Ä
Chapter 8.7
‘Changing the seals’
on page 35
).
Leakage on the
clamping screw n Needle seal
defective n Replace the needle
seal (
Ä
Chapter 8.7
‘Changing the seals’
on page 35
).
Material nozzle drips n Worn or damaged
material needle n Change the material
needle (
Ä Chapter 8.6
‘Changing the material
needle’ on page 33
).
n Dirty or damaged
material nozzle n Clean (
Ä
Chapter 8.4
‘Cleaning the hand-held
spray gun’ on page 29
)
or replace ( Ä Chapter
8.5 ‘Changing the
material nozzle and the
air nozzle’ on page 32
)
the material nozzle.
9.1 Customer Care
Krautzberger GmbH
Customer service
Stockbornstr. 13
65343 Eltville am Rhein
+49 6123 - 698151
customercare@krautzberger.com
Operating instructions
T-Dok-692-GB-Rev.0
mail@krautzberger.com, www.krautzberger.com GB–40