WARNING!
Risk of fatal injury, risk of injury or property damage due to damaged or disconnected
lines!
Damaged or disconnected lines can cause death, serious injuries or property damage due to
whip-like movements and the spraying of fluids.
Note:
–
Check the fluid pressure lines for damage and a tight fit prior to every work process.
7.2 General information about commissioning and start-up
Adhere to the following general information for commissioning:
n
Only carry out the commissioning of the automatic spray gun pursuant to the steps described
in this operating manual.
n
Check the material and compressed air hose lines for damage and tight fit before each use.
n
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations applicable for the area of use for the auto-
matic spray gun.
n
Do not use sharply abrasive, chemically aggressive, very hot or very cold spray fluids without
first consulting with and receiving approval from Krautzberger GmbH.
n
Adhere to the safety data sheets of the spray fluid manufacturer.
n
Only operate the automatic spray gun while adhering to the values specified in (
13 ‘Technical data’ on page 42
).
n
Only operate the automatic spray gun after proper fastening on a suitable carrier construction.
n
Do not hold the automatic spray gun in your hand during operation.
n
Never point the compressed air at living beings.
n
Adhere to the operating manuals for the respective components.
7.3 Operation
To achieve optimal results, adhere to the following:
–
Rinse the automatic spray gun with cleaning products before commissioning.
–
Too-high air pressure causes unnecessarily high air consumption and too-strong atomi-
sation of the spray fluid.
–
Too-low air pressure produces an unsatisfactory spray pattern.
–
Select the lowest possible fluid pressure.
Operating instructions
T-Dok-040-GB-Rev.5
[email protected], www.krautzberger.com
GB–22
Summary of Contents for 200-0148
Page 48: ......
