- 14 -
Dear Customer,
Thank you for choosing one of our appliances. It is very easy to use, but we do strongly recommend that
you carefully read these instructions which include advice on how to use and install your appliance in
order to obtain optimum results.
Reception and unpacking
Any damage due to transport must be reported to the carrier by registered letter with acknowledgement of
receipt, within 24 hours of receiving your appliance. You must also note your reserves on the carrier's
delivery note, describing in detail the damage noted on delivery.
General rules applicable to electrical equipment
When using electrical appliances, safety precautions must always be taken:
Read all the instructions carefully.
§
This appliance is not designed for use by people (including children) whose physical, sensorial or
mental capacities are impaired or by people with no experience or knowledge, unless they have
been supervised or given training in the use of the appliance beforehand by a person responsible
for their safety.
§
Close supervision is necessary when an appliance is used by children, or in their presence.
§
The appliance must never be left without supervision during use.
§
Do not use the appliance for anything other than the purpose which is described.
§
There is a risk of accidents if accessories are used that are not recommended by the manufacturer
of the appliance.
§
The appliance must be earthed.
§
The appliance must be connected to the mains by means of a residual (differential) current device
with a rated residual operating current of 30mA maximum.
§
It is recommended to examine the power supply cable regularly in order to detect any signs of
deterioration.
§
Do not connect nor use any appliance with a damaged plug or cable. If the power supply cord is
damaged, it must be replaced by the manufacturer, its after-sales service or a similar qualified
person to avoid any danger.
§
If the appliance has been damaged, send it to the closest authorised repair workshop or where
you bought it from for inspection and repair.
§
The appliance is not designed to be switched on by an external timer or separate remote control
system.
§
If you need to use an extension lead, take care to unwind the whole length in order to avoid the
cable overheating.
§
Always connect the cable to the power socket with the setting knob set at minimum. To disconnect
it, put the setting knob to minimum then remove the plug from the socket.
§
In order to avoid electric shocks, do not immerse the cable, socket or body of the appliance in
water or any other liquid. Do not handle with wet hands either.
§
Do not let the cord hang over the edge of a table or counter.
§
Do not put the appliance nor its cable on or near a hot surface (electric hotplate, hot gas burner,
heated oven etc).
§
Disconnect the plug when the appliance is not in use or before cleaning.
§
The appliance must not be cleaned by immersion, with a high or low pressure jet.
