KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the WP-209
8
5.1 Installing the WP-209
To install your
WP-209
:
1. Connect the HD15M output connector
1
to the pre-installed wiring in the
wall box opening that connects to the UXGA acceptor (for example, a
projector), as Figure 7 defines.
2. Connect the AUDIO output (for example, to a power amplifier with
speakers), as one of the following:
Figure 6: Connecting the AUDIO Output
3. Connect your 12V DC power supply to the
POWER
pins
2
, taking care that
polarity is correct
.
4. Insert the
WP-209
directly into the wall box opening, and then mount the
front panel securely using the screws.
5.2 Operating the WP-209
To operate your
WP-209
:
1. Connect your computer graphic’s source (for example, a laptop’s digital
graphics card) to the PC INPUT HD15F connector and to the PC INPUT
audio 3.5mm mini jack, for example, using a Kramer C-GMA/GMA cable
(VGA HD15M +Audio jack to VGA HD15M +Audio jack)
3
. (Alternatively,
you can connect
separate
audio source to the PC AUDIO INPUT.).
2. Connect the LOOP HD15F connector to an additional display
3. Connect the video source (for example, a composite video player) to the
VIDEO RCA connector and to the LEFT and RIGHT audio RCA
connectors.
4. If required, connect the ETHERNET RJ-45 connector.
1 For component HDTV, use a breakout VGA-to-RCA/BNC cable (for example, the Kramer C-GM/3RVF cable). For direct
wiring, the output connector PINOUT is as follows: PIN 1 for Pr; PIN 2 for Y; and PIN 3 for Pb
2 Connect the wire labeled “+” to the +12V pin, and the wire labeled “–” to the GND pin
3 Not supplied. The complete list of Kramer cables is on our Web site at http://www.kramerelectronics.com
