VS-6464DN - Using the Configuration Menu
25
7
Using the Configuration Menu
The configuration menus let you configure the
VS-6464DN
to best suit your needs.
There are two configuration menus:
Setup Menu
—those that are accessed on a regular basis (for example,
storing setups and setting the delay), see
Section
7.1
Config Menu
—those that are accessed only occasionally (for example,
setting the interface or communication protocol), see
Section
7.2
The following rules apply to the menu operation:
If no selection is made within approximately 15 seconds, the operation
times-out and the display reverts to the output/input display
At any point in the Menu, press ESC to move up one level or press
BREAKAWAY to exit the Menu altogether
At any point in the Menu, only buttons that are active light or flash
All of the procedures in this section assume that you are starting the
procedure from the standard, operational output/input display
7.1
Using the Setup Menu
The Setup Menu provides access to settings that are regularly changed and
comprises the following options:
1: inXX=>ALL
, switching one input to all outputs (see
Section
7.1.1
)
3: outXX=OFF
, turning off an output (see
Section
7.1.2
)
7: EDID
, assignment to an output (see
Section
7.1.3
)
9: Delay
setting for an output (see
Section
7.1.4
)
4: store setup XX
, storing the setup in a preset (see
Section
7.1.5
)
6: recall setup XX
, recalling a preset (see
Section
7.1.6
)