16
VS-42HN - Operating the VS-42HN 4x2 HDMI Matrix Switcher
The input front panel buttons’ status indicates the HDCP state of each input:
HDCP enabled (ON) on an input
– that input button is illuminated
HDCP disabled (OFF) on an input
– that button is not illuminated
3. Press an input button to change its status.
You can press one or more inputs.
4. Once you have changed the status of HDCP on the inputs as desired, press
the EDID to save the changes and exit the HDCP enable/disable mode to
return to normal operation.
Note
: If the EDID button is not pressed within about 12 seconds, the device exits
the port HDCP On/Off mode automatically and all changes are lost.
6.7
Resetting the IP Parameters
This procedure resets only the IP related parameters. All switching and
preset values remain unchanged.
To reset the IP parameters to their default values
(see
Section
8
):
Press and hold the ETH Reset button on the rear panel while powering up
the device
6.8
Switching Between Protocol 2000 and Protocol 3000
To switch from Protocol 2000 to Protocol 3000 and back again using the
front panel buttons
:
1. On the TO OUTPUT 1 row, press input buttons 1 and 3 at the same time.
Protocol 3000 is active.
2. On the TO OUTPUT 1 row, press input buttons 1 and 2 at the same time.
Protocol 2000 is active.
i